JQ43 Jetstar - Flight Status

Which is the frequency of flight JQ43?
The flight JQ43 is scheduled to flight on daily basis.

Which is the distance of flight JQ43?
The distance between the two airports is 4383 kilometers.

Which is the flight time of flight JQ43?
The scheduled flight time gate to gate is: 06:05 hours.
The real flight time gate to gate on average is: 05:03 hours.

Are the departure airport and arrival airport at the same Time Zone?
No, each airport is in a different timezone. The times shown above, are presented in the local time of each respective airport.
Current Time in Melbourne: 2024-05-11 05:14:20
Current Time in Denpasar: 2024-05-11 03:14:20

The following airlines serves the same route between Melbourne and Denpasar:

Garuda Indonesia
- Flight Number: GA719. (On Time performance: 40 - Average Delay: 26 minutes)

Jetstar
- Flight Number: JQ31. (On Time performance: 94 - Average Delay: 5 minutes)
- Flight Number: JQ35. (On Time performance: 81 - Average Delay: 9 minutes)

Batik Air Malaysia
- Flight Number: OD178. (On Time performance: 90 - Average Delay: 5 minutes)

Qantas
- Flight Number: QF45. (On Time performance: 86 - Average Delay: 7 minutes)

Virgin Australia
- Flight Number: VA91. (On Time performance: 80 - Average Delay: 7 minutes)
- Flight Number: VA95. (On Time performance: 94 - Average Delay: 3 minutes)

We have gathered data from recent months and present below an analysis of how timely the flights have been.

Delays analyzed by Week: It is not possible to calculate the On-Time Performance for this flight accurately by weekday due to insufficient or non-representative data, as doing so could lead to misleading conclusions
Delays analyzed by Month: We have gathered available data from last twelve closed months, spanning from May 02, 2023 to April 30, 2024. Next, you can observe the results broken down by month: number of flights analyzed, on-time performance per month, and average delay per month.

Note: We have excluded some months from the graph, since the quantity and quality of the data is not representative enough.